Korg R3 Manuel d'utilisateur télécharger pdf (Page 85)

79

Other SHIFT key functions

DEMO

Listening to the demo performance

•Hold down the [SHIFT] button and

press the ARPEGGIATOR [ON/OFF]

switch.

The demo will begin playing. While the

demo is playing, you can stop it by

pressing the [EXIT] switch.

Refer to p.11 for details on how to se-

lect songs.

CALIBRATION

Calibrating the foot pedal

1

Connect a foot pedal (☞p.8). Begin this

operation with the pedal set all the way

down.

2

Hold down the [SHIFT] button and

press the ARPEGGIATOR [LATCH]

switch.

The [LATCH] switch will blink.

The main display will show the calibra-

tion setting screen.

3

Advance the foot pedal all the way up, and

then return it to the fully down position.

4

Make sure that the lower line of the

main display shows “********”.

5

To execute the calibration, press the

[LATCH] switch.

The calibration settings will be loaded,

and you’ll return to Play mode. To save

the settings, write the Global data

(☞p.74 “Saving GLOBAL and MIDI set-

tings”).

If you decide to cancel the calibration

operation, press the [EXIT] button.

TIMBRE1 SOLO, TIMBRE2 SOLO

Soloing a timbre

For a program that uses two timbres, this

operation lets you listen to just one of the

timbres. While editing, you can use this

when you want to hear a single timbre by

itself.

1

Hold down the [SHIFT] button and

press the TIMBRE SELECT [TIMBRE

1] or [TIMBRE 2] button. Only the tim-

bre whose button you press will be

heard.

2

Hold down the [SHIFT] button and

press the TIMBRE SELECT button

([TIMBRE 1] or [TIMBRE 2]) of the tim-

bre that you were soloing.

The solo setting will be defeated.

If you execute this while editing, the

timbre being edited will change.

AUDIO IN THRU

Audio In Thru

This operation causes the audio signal from

the input jacks to be sent directly to the

OUTPUT [L/MONO] and [R] jacks.

• Hold down the [SHIFT] button and

press the [VOCODER] button.

When this function is on, the audio sig-

nal from the [AUDIO INPUT 1] (or

[MIC]) and [AUDIO INPUT 2] jacks will

be passed through and sent from the

OUTPUT [L/MONO] and [R] jacks.

This will turn on/off each time you

press the button.

The 41. Global-B page “Thru Src” pa-

rameter specifies the input jack(s) to

which the Thru function will apply.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 93 94

Commentaires sur ces manuels

Pas de commentaire