Korg Performance Synthesizer PS60 Manuel d'utilisateur télécharger pdf (Page 11)

Setting up the PS60 Plug-In Editor

If you want to use the PS60 Editor with the PS60 connected to your computer via USB, you

must make sure that you have finished installing and setting-up the KORG USB-MIDI Driver

before you start up the PS60 Editor.

This section explains how to set up the PS60 Plug-In Editor in your host application and adjust the

settings so that it will function correctly.

About the PS60 Plug-In Editor

Parameter data is sent and received between the PS60 Plug-In Editor and the PS60. Unlike typical

plug-in instruments, the PS60 Plug-In Editor does not produce an audio signal.

Your PS60 will output audio signals when the PS60 Plug-In Editor sends it MIDI messages.

If you want to send the PS60’s audio signal to an audio track of your host application and use it in

conjunction with a plug-in effect etc., refer to “Using your host application to control the PS60’s

audio signal” (

)

p.9)

Note

: Because the PS60 Plug-In Editor does not handle audio signals, you can’t insert a plug-in

effect into the channel of the track where the PS60 Plug-In Editor is inserted, or send its audio

signal via a send or bus.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 36 37

Pas de commentaire

Korg Performance Synthesizer PS60 Manuel d'utilisateur Page 11